{"id":4097,"date":"2021-12-26T18:08:48","date_gmt":"2021-12-26T16:08:48","guid":{"rendered":"https:\/\/patterns.bplaced.net\/blog\/?p=4097"},"modified":"2022-01-07T15:44:30","modified_gmt":"2022-01-07T13:44:30","slug":"an-18th-century-mens-shirt","status":"publish","type":"post","link":"https:\/\/patterns.bplaced.net\/blog\/?p=4097","title":{"rendered":"An 18th century men\u00b4s shirt – Part 1"},"content":{"rendered":"\n

I\u00b4m back in the 1790\u00b4s! No special occasion is coming up, just that I planned to finish the 1790\u00b4s men\u00b4s pattern series with a shirt which I have so far neglected.<\/p>\n\n\n\n

Men\u00b4s shirts are quite simple garment\u00b4s, made from rectangular pieces of fabric and have changed less than other garments during the last centuries. Therefore, the shirt in this pattern can be used for costumes over several decades, from about 1750 to 1830.<\/p>\n\n\n\n

\"\"<\/figure>\n\n\n\n

Gussets at the underarm and shoulder slope gave the shape needed. The shoulders were reinforced with additional patches, attached to the inside of the shirt with a fell or slip stitch. There are several ways to insert gussets, attach shoulder patches or cast all the raw edges, especially at the armhole. My templates are three extant men\u00b4s shirts displayed at the \u201cGermanisches Nationalmuseum\u201d in N\u00fcrmberg, Germany.   <\/p>\n\n\n\n

Let\u00b4s start sewing, following the pattern instructions step by step.<\/p>\n\n\n\n

You prefer a sewing pattern rather than a diagram? Go to my Shop and get yours!<\/a><\/p>\n\n\n\n

(1)<\/strong> Of course, my step #1always is to cut and prepare the pieces from fabric, marking all the notches. I made the shirt from a fine linen. When sewing with linen, it\u00b4s important to pre-wash the fabric at least with the same temperature as you\u00b4re going to wash the shirt later. Cutting linen in the straight grain can be tricky as well, I prefer to pull out single threads. This can be boring and time consuming, but in the end it\u00b4s worth it.<\/p>\n\n\n\n

(2)<\/strong> This is the shirt bodice, slashed horizontally for the neck opening, and slashed down the center front at the chest. Along slash at the center front, a narrow seam allowance is double-turned in and fell stitched in place. To hold the edge of the fabric straight when sewing, I used a plastic clamp from the hardware store (my third hand).<\/p>\n\n\n\n

\"\"<\/figure><\/div>\n\n\n\n

(3)<\/strong> When I first started sewing a 18th<\/sup> century men’s shirt, the most difficult thing I found was the shoulder patches and gussets. Because of this, I’m going to show it in great detail.<\/p>\n\n\n\n

Take the shoulder gussets and turn in the seam allowances along two consecutive edges, or along all edges as shown in the pictures.<\/p>\n\n\n\n

\"\"<\/figure><\/div>\n\n\n\n

Slash the shoulder patch and turn in the seam allowances (except along the armhole edge) and insert the gusset as shown. It is shown and described a little differently in the instructions, only at the end the result will be the same.<\/p>\n\n\n\n

\"\"<\/figure><\/div>\n\n\n\n
\"\"<\/figure><\/div>\n\n\n\n\n\n\n\n
\"\"<\/figure><\/div>\n\n\n\n
\"\"<\/figure><\/div>\n\n\n\n

Again, the slashed neck opening, followed by the shoulder patch, placed on the inside of the shirt bodice. The corners of the slashes are matching, the edges of the patch are following the grain line of the bodice. All following pictures are showing, how to stitch the patch and the gusset in place, after notching the seam allowance of the neck-opening.<\/p>\n\n\n\n

\"\"<\/figure><\/div>\n\n\n\n
\"\"<\/figure><\/div>\n\n\n\n
\"\"<\/figure><\/div>\n\n\n\n
\"\"<\/figure><\/div>\n\n\n\n
\"\"
The wrong side of the shirt bodice<\/figcaption><\/figure><\/div>\n\n\n\n
\"\"
The right side, with tiny stitches barely showing<\/figcaption><\/figure><\/div>\n\n\n\n
\"\"
Again, the right bodice side<\/figcaption><\/figure><\/div>\n\n\n\n
\"\"<\/figure><\/div>\n\n\n\n
\"\"<\/figure><\/div>\n\n\n\n

(4)<\/strong> To prepare the collar, turn in the seam allowances first, then fold in half lengthwise and sew along the short edges (be aware, the pictures are showing the narrow cuffs, not the collar, they\u00b4re just made up the same way). Turn the right way out an press. <\/p>\n\n\n\n

\"\"<\/figure><\/div>\n\n\n\n
\"\"<\/figure><\/div>\n\n\n\n

Here you can see the bottom edge of the outer collar lined up with the stitching line on the right side of the gathered neck opening, the folds are spread evenly. When sewing the collar to the shirt, every single fold is stitched in place individually. After sewing the outer collar, the seam allowances are trimmed back and the inner collar is lined up with the stitching line on the wrong side. Again, catch every single pleat individually when stitching down the inner collar. <\/p>\n\n\n\n

\"\"<\/figure><\/div>\n\n\n\n
\"\"<\/figure><\/div>\n\n\n\n
\"\"<\/figure><\/div>\n\n\n\n
\"\"<\/figure><\/div>\n\n\n\n

Part 2: The sleeves and finishing details<\/a><\/p>\n\n\n\n

Part 3:<\/a> Ruffles, Stock and Neckerchief<\/p>\n","protected":false},"excerpt":{"rendered":"

I\u00b4m back in the 1790\u00b4s! No special occasion is coming up, just that I planned to finish the 1790\u00b4s men\u00b4s pattern series with a shirt which I have so far neglected. Men\u00b4s shirts are quite simple garment\u00b4s, made from rectangular pieces of fabric and have changed less than other garments during the last centuries. Therefore, […]<\/p>\n","protected":false},"author":1,"featured_media":4186,"comment_status":"open","ping_status":"closed","sticky":false,"template":"","format":"standard","meta":{"footnotes":""},"categories":[30,59,38,6],"tags":[60,61],"class_list":["post-4097","post","type-post","status-publish","format-standard","has-post-thumbnail","hentry","category-1830-60-mens-shirt","category-0521-18th-century-mens-shirt","category-18th-century-18-jahrhundert","category-tutorials","tag-18th-century-mens-shirt","tag-reenactment"],"_links":{"self":[{"href":"https:\/\/patterns.bplaced.net\/blog\/index.php?rest_route=\/wp\/v2\/posts\/4097","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/patterns.bplaced.net\/blog\/index.php?rest_route=\/wp\/v2\/posts"}],"about":[{"href":"https:\/\/patterns.bplaced.net\/blog\/index.php?rest_route=\/wp\/v2\/types\/post"}],"author":[{"embeddable":true,"href":"https:\/\/patterns.bplaced.net\/blog\/index.php?rest_route=\/wp\/v2\/users\/1"}],"replies":[{"embeddable":true,"href":"https:\/\/patterns.bplaced.net\/blog\/index.php?rest_route=%2Fwp%2Fv2%2Fcomments&post=4097"}],"version-history":[{"count":30,"href":"https:\/\/patterns.bplaced.net\/blog\/index.php?rest_route=\/wp\/v2\/posts\/4097\/revisions"}],"predecessor-version":[{"id":4260,"href":"https:\/\/patterns.bplaced.net\/blog\/index.php?rest_route=\/wp\/v2\/posts\/4097\/revisions\/4260"}],"wp:featuredmedia":[{"embeddable":true,"href":"https:\/\/patterns.bplaced.net\/blog\/index.php?rest_route=\/wp\/v2\/media\/4186"}],"wp:attachment":[{"href":"https:\/\/patterns.bplaced.net\/blog\/index.php?rest_route=%2Fwp%2Fv2%2Fmedia&parent=4097"}],"wp:term":[{"taxonomy":"category","embeddable":true,"href":"https:\/\/patterns.bplaced.net\/blog\/index.php?rest_route=%2Fwp%2Fv2%2Fcategories&post=4097"},{"taxonomy":"post_tag","embeddable":true,"href":"https:\/\/patterns.bplaced.net\/blog\/index.php?rest_route=%2Fwp%2Fv2%2Ftags&post=4097"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}